Spin-N-Trim Hull Trimmer - 12 Gauge         

The tool that quickly & easily trims empty hulls.

We've seen many different versions over the years, but we can confidently say that ours is the most efficient trimmer we've ever seen.  We've simplified the action and designed this trimmer so that a spring does all the hard work of applying force between the blade and the hull. You can easily hold the Spin-N-Trim in one hand while you spin the hull with the other hand. It's really that easy.

The Spin-N-Trim is not compatible with 12ga 2-3/4" tapered hulls (i.e., Winchester AA HS, Remington STS/Nitro/Gun Club, and Federal HOA) as the tapered interior design precludes the roller bale from being fully inserted into the hull.

Three-Second Instructions for 12ga:

1. The maximum cut depth is 1/2-inch. Adjust the stop nut and cut-depth bolt to your desired cut depth if you desire less than a 1/2-inch cut.

2. Release blade pressure on the thumb tab and insert empty hull over the tube bushing.

3. Allow the blade arm to apply pressure to the hull. Grasp the hull by the base and rotate the Spin-N-Trim around the hull.

That's all there is to it. A quick and easy adjustable trim of the hull is completed with just a quick spin. The Curmudgeon says, if you trim hulls, then this is your tool.

For 10ga 2-7/8" hulls:

Our ballistic lab tested 10ga 2-7/8" loads and successfully used the Spin-N-Trim to cut down Cheddite 10ga 3-1/2" hulls. It is important to keep the mouth of the hull pressed toward the front of the tool in order to avoid a spiral cut. It took us a couple tries, but it worked very well.

Replacement Blade: Click here to buy replacement blades for the Spin-N-Trim tool.

Replacement Roller Bale: Click here to buy a replacement roller bale for the Spin-N-Trim tool.

Warning: This product features a sharp blade. Always keep hands and fingers away from the cutting area.

Made in China